Cisco SG300-10PP 10 port Gigabit POE+ switch. 2 X Combo SFP ports. Rackmount Gigabit POE Fully managed switch. Latest firmware 1.4.11.02 (Oct 2019). 8 x Gigabit POE interfaces.
2 x Gigabit Ethernet/SFP Combo interfaces. Complete with rackmount wings, original PSU, serial console cable. Can be configured via web interface or cli.
3 available - pictures are of one of the units for illustration purposes and may not be the one you receive. Factory reset - Default IP 192.168.1.254. Product Description - 8 10/100/1000 PoE+ ports with 62W power budget, 2 Combo mini-GBIC ports.General Device Type - Switch - 10 ports - L3 - managed. Enclosure Type - Desktop, rack-mountable - 1U Ports 8-port Gigabit + 2 x combo Gigabit SFP Power Over Ethernet (PoE) POE and POE+. Performance Switching capacity : 20 Gbps ¦ Forwarding performance (64-byte packet size) : 14.88 Mpps.
MAC Address Table Size - 16K entries. Capacity - 4K Active VLANs. Routing Protocol - Static IPv4 routing. Remote Management Protocol - SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, HTTPS, SSH, CLI.
Jumbo Frame Support - 9KB. Authentication Method - Secure Shell (SSH), RADIUS, TACACS+. Features - Layer 3 switching, Layer 2 switching, DHCP support, VLAN support, IGMP snooping, syslog support, DoS attack prevention, port mirroring, DiffServ support, weighted round-robin (WRR) queuing, broadcast storm control, IPv6 support, multicast storm control, unicast storm control, firmware upgradable, Spanning Tree Protocol (STP) support, Rapid Spanning Tree Protocol (RSTP) support, Multiple Spanning Tree Protocol (MSTP) support, Trivial File Transfer Protocol (TFTP) support, access control list (ACL) support, quality of service (QoS), jumbo frames support, MLD snooping.Flash Memory - 16 MB flash. Status Indicators - Link activity, port transmission speed, system. Interfaces - 8 x 10Base-T/100Base-TX - RJ-45 - PoE ¦ 1 x console - 9 pin D-Sub (DB-9) - management ¦ 2 x 10Base-T/100Base-TX/1000Base-T - RJ-45 / SFP (combo). Power Device - Power adapter - external. Voltage Required - AC 120/230 V (50/60 Hz). Width 11 in Depth 6.7 in Height 1.45 in Weight 2.73 lbs.
Cables Included - 1 x serial cable. Rack Mounting Kit - Included. Please note: On first time bootup after factory reset, these switches can take upto 5 mins to boot.After configuration, bootup is much faster. The item "Cisco SG300-10PP 10 port Gigabit POE+ switch. 2 X SFP combo ports" is in sale since Saturday, December 7, 2019. This item is in the category "Computers/Tablets & Networking\Enterprise Networking, Servers\Switches & Hubs\Network Switches".
The seller is "css-networks" and is located in Stroud. This item can be shipped to United Kingdom.